|
 | Note: Remember to use the white Information Key on the Front Panel to gain access to additional, important details about the current display message, such as jam clearing instructions and information about re-ordering Supplies.
|
 | Phaser® 6200 Transparency film is designed specifically to work with this printer's oil-less fuser. Using non-Phaser 6200 Transparencies might result in poor image quality and might damage the fuser. Damage caused by using non-Phaser 6200 Transparencies is not covered under the warranty, service agreement, or Total Satisfaction Guarantee. To order Phaser 6200 Transparencies, visit the Phaser® 6200 Supplies and Accessories web site. DO NOT load Phaser® 6200 Transparency Film in Trays 2 or 3; use Tray 1 or the Multi-Purpose Tray instead. |
Please see Ordering Information for supplies, prices, and part numbers.
| | DO NOT load card stock, glossy coated paper, photo paper, envelopes, labels, business cards, greeting cards, CD/DVD labels, and CD/DVD inserts in Trays 1 - 3; use the Multi-Purpose Tray instead. |
To load transparencies in the tray:
- Pull out the tray.
- Push the width guides outward. If transparencies being loaded have a different length, tilt the back guide forward, slide the guide, and insert the pins on the bottom of the guide into the holes in the tray corresponding to the transparency size you are loading.
- Fan the transparencies to release sheets that are stuck together.
- Insert a stack of transparencies into the tray. Place the transparencies under the front corner tabs and under the tabs on the back guide.
| | Note: Observe the fill lines on the side of the tray. Do not load transparencies above the transparency fill line, because it may cause a jam. |
- If necessary, push the width guides inward to match the size of the transparency.
| | Note: Failure to set the rear guide to the correct paper size or secure the width guides snugly against the transparencies may cause mis-picks or jams. |
- Insert the tray and push it completely into the printer.
- When the front panel prompts you:
- If you were using transparency for the previous print job, press the OK key to accept the current setting for Phaser 6200 transparency.
- If you have changed the type of paper from the previous print job, scroll to Phaser 6200 transparency and press the OK key to save your selection.
| | Note: To avoid possible print-quality and transparency-feed problems, always make sure the tray's transparency type setting on the front panel matches the type of transparency loaded in the tray. |
|
